385 Simple Solutions Videos
How to Install Brass Screws Without BreakingBy: Joe Truini
Brass hardware adds to the look of woodworking projects, but brass screws are much softer than steel and can break easily when installing. To prevent this from happening:
- Drill a pilot hole slightly smaller than the diameter of the brass screw.
- Screw a steel screw the same size as the brass screw into the hole.
- Remove the steel screw, and screw the brass screw in the threaded hole.
Watch this video to find out more.
- How to Lubricate Screws Using Wax (video)
- Installing Screw Hooks the Easy Way (video)
- Easy Screw Holder (video)
- How to Make a Drilling Jig for Cabinet Handles and Knobs (video)
Please Leave a Comment
We want to hear from you! In addition to posting comments on articles and videos, you can also send your comments and questions to us on our contact page or at (800) 946-4420. While we can't answer them all, we may use your question on our Today's Homeowner radio or TV show, or online at todayshomeowner.com.
Joe Truini: Brass hinges and hardware can add a decorative look to virtually any home-improvement project. The challenge though is that brass screws are a lot softer than steel screws. If you’re not careful when you drive them in you can snap them off or strip the head, so here’s the trick.
Start by drilling a pilot hole for the screw. Now this you’d need to do no matter what kind of screw you’re driving in. It’s particularly important when you’re driving into hardwood as I am here with this oak. And then, and here’s the real trick, is take a steel screw that’s the same size as the brass screw and drive it into the hole. And once it’s fully seated back it out.
What you’ve done is you’ve effectively threaded the wood with the exact right size hole for now putting in the brass screw. Now that we have that hole this will go in easily without fear of stripping it or snapping it off. There you go. Perfect.
And again, this works on any kind of wood. But is particularly important when you’re doing hardwood like this oak. Because the screw will bite into that wood and snap off without that perfect sized pilot hole.