Expert Home Improvement Advice
How To • Videos • Lawn & Garden • DIY • Articles
How to Paint Both Sides of a Door on Sawhorses
Watch this video for a simple tip on how to paint both sides of a door while it’s laying on sawhorses. ...More
How to Paint Both Sides of a Door on SawhorsesBy: Joe Truini
Putting a door horizontally on sawhorses while painting is a great way to prevent drips and runs, but it makes it hard to paint both sides at the same time. Here’s a simple solution to solve the problem:
- Paint the other side of the door, and allow the paint to dry thoroughly before removing from the sawhorses.
Watch this video to find out more.
Please Leave a Comment
8 Comments on “How to Paint Both Sides of a Door on Sawhorses”
You can follow comments to this article by subscribing to the RSS news feed with your favorite feed reader.
We want to hear from you! In addition to posting comments on articles and videos, you can also send your comments and questions to us on our contact page or at (800) 946-4420. While we can't answer them all, we may use your question on our Today's Homeowner radio or TV show, or online at todayshomeowner.com.
Painting doors is much easier to do if the doors are off its hinges. What I like to do is set the door horizontally on a couple of sawhorses. That allows you to apply the paint, and the paint won’t run and drip off the surface.
Once you get one side painted, what do you do? You can’t just flip it over and rest it on the sawhorses. So here’s the trick. Take two three inch drywall screws, and drive them through the end of the door, leaving about an inch to an inch and a half of screw sticking out.
Then come down to the other end of the door, and just drive one screw right in the center. Again, leave about half of it sticking out. This is the pivot screw, and I’ll show you why they call it the pivot screw.
Pull the sawhorse out, and rest the screw head right on top of the sawhorse. Then you come down here, and use these two screws as handles. Pull out the sawhorse a little bit, and just rotate the door. See that, how easy that is. And you set it again, with screws right on top of the sawhorse.
Now, you have the freshly painted surface underneath, and this clean surface ready to paint right now.