Expert Home Improvement Advice
How To • Videos • Lawn & Garden • DIY • Articles
Using a Step Drill Bit to Drill Different Size Holes
Find out about step drill bits, which can be used to drill a dozen different size holes in thin stock with only one drill bit. Watch this video to find out more. ...More
A step drill bit can be used to drill a range of different sized holes with a single bit. Since each bit size drill holes less than 1/4″ deep, a step bit is mainly used for drilling thin material such as sheet metal.
To make it easy know how deep to plunge the bit for the right sized hole, wrap a piece of masking tape around the bit at correct hole size. Watch this video to find out more.
- Drill Bit Depth Gauge (video)
- Drilling Into Tile (video)
- Stop Drill Bit from Wandering When Drilling Metal (video)
- Preventing Tear Out When Drilling Wood (video)
Please Leave a Comment
We want to hear from you! In addition to posting comments on articles and videos, you can also send your comments and questions to us on our contact page or at (800) 946-4420. While we can't answer them all, we may use your question on our Today's Homeowner radio or TV show, or online at todayshomeowner.com.
Joe Truini: I just drilled these 13 different size holes using a single drill bit. That’s possible because I used a step drill bit. This single bit, will drill 13 different holes, ranging in diameter from about eighth-inch to half inch. And here is how it works.
Start drilling, and with each step of the drill, you’re getting a larger and larger hole. So we get started right here. There you go, that’s an eighth-inch. Now it’ll start cutting pretty quickly, and again, each step the hole gets larger and larger. There you go.
Now, the trick to using a step drill is, when do you stop at exact right size hole, because you don’t want to stop and keep measuring. So here’s an additional tip. Take a piece of tape and wrap it around the bit exactly where you want to stop drilling. In this case, about a quarter inch. Then you just keep drilling until you hit the tape. And then stop, and you get the exact size hole.