Win Danny and His Crew Contest Winner 2015
As the winners of our 2015 “Win Danny & His Crew” Contest, we’re helping homeowners Anissa and Jerry Arnold of Hahnville, Louisiana, tackle their to-do list, from downspout and shutter repairs to cabinet touch-ups and installing a new kitchen range hood.
Like most homeowners, Anissa and Jerry had a sizeable to-do list for their home; and, because of our contest, we were able to tackle many of their projects for them in just a few days.
To-Do List Projects Included:
- Gutter Downspout Repair: We reattached the damaged downspout using sheet metal screws and Titebond Ultimate MP Sealant.
- Fix Front Door Lock: After the bent locking mechanism had been straightened and lubricated, the lockset worked perfectly.
- Attach Loose Shutters: We removed the broken plastic shutter pins and attached the shutters to the house using long screws.
- Repair Microwave Trim: We shaved 1/8″ off the trim around the microwave so it would fit properly.
- Replace GFCI Outlets: We replaced the existing Ground Fault Circuit Interrupter (GFCI) outlets in the kitchen with new Leviton SmartlockPro Self-Test GFCI outlets (model # S7599-W). Find out how to replace a wall outlet.
- Fix Leaking Kitchen Sink Strainer: To repair the leaking garbage disposal sink strainer in the kitchen, we installed a rubber gasket below the sink and applied plumber’s putty around the drain inside the sink. Find out how to replace a sink strainer
- Repair Bath Vanity Finish: To fix the damaged melamine coating on the bathroom vanity, we sanded down the cabinet frame, and sprayed it with a bonding primer followed by two coats of semi-gloss spray paint.
- Fix Bath Fan: To lower the humidity in the bathroom, we installed a Humidity Sensor and Fan Control Switch (IPHS5-1LW) from Leviton, which automatically turns the fan on when the humidity is too high and off when the moist air has been removed. We also cleaned and painted the yellowed bath fan cover to improve the look of the fan.
- Install Range Hood: We added a new, stainless steel Broan Elite range hood (model E5490SS) over the kitchen island cooktop. The fan is rated at 480 CFM and has a Heat Sentry feature that adjusts the blower speed to high automatically when excess heat is detected. To cover the hole left by the recessed light fixture, we made a ceiling medallion from 1/4″ plywood trimmed with panel molding. Find out how to install a range hood.
- Clean & Repair Kitchen Cabinets: Our final project was to clean the kitchen cabinets using a hot sponge and citrus cleaner, and repair cabinet scratches with a stain pen.
Other Tips from This Episode
Simple Solutions with Joe Truini:
Cleaning Copper Cookware
To clean copper cookware, pour white vinegar in a skillet, add salt, and heat it to almost boiling. Soak the bottom of the copper pan in the vinegar for 10 minutes. Sprinkle salt on a sponge dipped in the hot vinegar to remove any remaining stains. (Watch Video)
Best New Products with Jodi Marks:
Kohler LED Nightlight Toilet Seat
The Kohler Cachet LED Nightlight Toilet Seat has battery powered LED lights to illuminate your way at night, and a quiet close lid to keep from waking everyone up. The Kohler Cachet LED Nightlight Toilet Seat is available at The Home Depot. (Watch Video)
Ask Danny Lipford:
Repairing Popped Nails in Drywall
To repair a popped nail in drywall, use pliers to remove the protruding nail, then drive 1½” long drywall screws into the stud above and below the nail hole. Apply several coats of drywall joint compound, sand the compound smooth, and paint the wall. (Watch Video)
You May Also Like:
|Win Danny 2015 Contest Winner||Win Danny 2012 Contest Winners||Win Danny & His Crew Contest Winn...||Winner Announced in Win Danny & H...|