How-To Videos

How to Properly Paint Cabinets

By: Danny Lipford

The key to properly painting cabinets is preparation.

With the doors removed from the boxes and all of the hardware off of the doors, you can begin lightly sanding the cabinet doors. The goal here is to rough up the surface enough to accept the primer.

A pad sander with 220-grit paper will make quick work of the flat areas and a sanding sponge is ideal for curved edges and recesses.

Spreading the doors out on two by fours stretched between sawhorses will allow you to prep and paint without moving the doors.

Before priming, wipe down all the surfaces with a damp rag to remove any dust.

If there is any greasy residue left after sanding, mineral spirits will remove it.

The next step is applying the primer, which blocks stains and promotes adhesion. We’re using a high-volume, low-pressure spray gun to apply both the primer and the paint.

These sprayers are inexpensive and very user-friendly but the operator should be protected by a respirator.

When you spray paint, it’s important to keep the spray tip a consistent distance from the surface and make slow passes back and forth.

Each pass should begin and end beyond the edge of the door so there’s no buildup of paint on the edges.

We’re using the same sprayer on the cabinet boxes inside since the floors are covered and the room is sealed.

In this case, we’re painting the inside of the cabinets to avoid overspray marks or the need to mask each opening of the cabinets.

After the primer dries, you may need to putty nail holes or caulk cracks and seams.

Next, the finish paint is applied. Spraying the doors horizontally like this reduces the risk of drips, which can mar the finish and are more common with spraying than brushing.

Allow the two coats of finish paint to dry thoroughly before handling the doors and replacing the hardware.

If you’re changing the hardware, consider buying new hinges with the exact same footprint of the old ones. This will simplify installation and hide any indentations live by the old hinges.

Watch the video above to see the entire process!


Comments

Please Leave a Comment

10 Comments on “How to Properly Paint Cabinets”

You can follow comments to this article by subscribing to the RSS news feed with your favorite feed reader.

  • Official Comment:


    Thomas Boni Says:
    June 24th, 2019 at 10:36 am

    Hi, Kathy,
    We used Homeright’s Finish Max HVLP sprayer for this project.
    Chelsea loves it!



  • Kathy Weber Says:
    June 23rd, 2019 at 6:06 pm

    What brand of paint sprayer was used on the kitchen cabinets in today’s episode. It looked easy to use and had great coverage. We’ve bought sorayers in the past and wasn’t happy with the results. Thank you!


  • Official Comment:


    Thomas Boni Says:
    June 24th, 2019 at 12:15 pm

    Hi, Abby,
    TSP’s basic function is to clean, not degloss. So sanding would be your best bet for this project.
    Good luck!



  • Abby Keister Says:
    June 22nd, 2019 at 1:23 pm

    Instead of sanding the cabinets, what do you think about using TSP?


  • Official Comment:


    Thomas Boni Says:
    June 21st, 2019 at 8:49 am

    Hi, Pat,

    Thanks for sharing your concern. Videos play from beginning to end for us, so we recommend a couple of things.
    First, check your internet connection and make sure it’s strong.
    Second, run a virus and spyware check, because malware can slow things down, too.

    Also: A representative from our support team will contact you directly — watch your email! 🙂
    Take care.



  • pat gress Says:
    June 21st, 2019 at 6:47 am

    Just a quick comment about the how to videos or any videos for that matter. They all start out great and then stop for about 10-15 seconds. I mentioned this before but apparently nothing has been corrected as of yet. It is just a little annoying when a person is trying to learn how to do something and the actual video stops and then starts numerous times.
    Thank you for allowing me to express my comments.



  • Kris Olsen Says:
    June 21st, 2019 at 4:37 am

    Excellent piece!



  • Jayne M Keene Says:
    June 20th, 2019 at 10:01 pm

    Hi!
    I have a small upstairs bathroom with a fiberglass tub, it’s wearing thin. What can I use to reinforce the surface? Does marine epoxy work? My kitchen is below, is there anything less toxic I can use?
    Love your show! Especially the banter between you and your daughter!
    Thanks 😘
    JJ


  • Official Comment:


    Thomas Boni Says:
    June 21st, 2019 at 9:23 am

    Hi, David,
    You can extend the life of your cabinets by applying a polyurethane finish. Here’s how to do that: https://www.todayshomeowner.com/how-to-apply-polyurethane-finish/
    Good luck!



  • David Burleson Says:
    June 20th, 2019 at 1:38 pm

    Thanks for the video. Do you put anything on after the paint to stop scratches and minor dings from happening.
    Thanks again.

    David


We want to hear from you! In addition to posting comments on articles and videos, you can also send your comments and questions to us on our contact page or at (800) 946-4420. While we can't answer them all, we may use your question on our Today's Homeowner radio or TV show, or online at todayshomeowner.com.

 characters available

How to Properly Paint Cabinets