Simple Solutions

Trick to Cut Crown Molding on Angle

By: Joe Truini

Trick for Cutting Crown Molding on Miter SawIn order to properly make miter cuts in crown molding you have to turn it upside down on the miter saw table. This allows the angled back edges to rest against the fence and the table during cutting. Holding the molding in exactly the right position while you make a cut is the difficult part. The solution is to hot glue a piece of one-by-two to the saw table so it acts as a cleat to hold the molding in the proper position.

Watch video above for all of the details on this Simple Solution!

Print  


Comments

Please Leave a Comment

One Comment on “Trick to Cut Crown Molding on Angle”

You can follow comments to this article by subscribing to the RSS news feed with your favorite feed reader.


  • Lewis Berry Says:
    February 8th, 2018 at 7:15 am

    Guys and gals…I watch your program each Saturday morning @6AM on WJBF Augusta, GA. I have learned a lot. Looking forward to taking on some repairs now that I have retired. Have a 18×18 section of sheetrock that was removed for plumber to install new tub/sbower hardware. I’ll check website to see if there is a video that would help. Have a great day.


We want to hear from you! In addition to posting comments on articles and videos, you can also send your comments and questions to us on our contact page or at (800) 946-4420. While we can't answer them all, we may use your question on our Today's Homeowner radio or TV show, or online at todayshomeowner.com.

Trick to Cut Crown Molding on Angle